Has anyone had this issue?
I have this short program I have written. It measures 4-way, 2-way (rotate), and a point (level). After my alignment is finished I then measure an 8mm hole and call back true position to it. This program ran fine, I saved and close the program. Next I mirror imaged this program to be able to measure opposite hand part, problem is it doesn't want to measure correctly. Came back the next day started over with mirror image of program and it ran fine. ???**???
I have this short program I have written. It measures 4-way, 2-way (rotate), and a point (level). After my alignment is finished I then measure an 8mm hole and call back true position to it. This program ran fine, I saved and close the program. Next I mirror imaged this program to be able to measure opposite hand part, problem is it doesn't want to measure correctly. Came back the next day started over with mirror image of program and it ran fine. ???**???