Good Day, All:
I have a situation that I believe has an easy solution...I just don't know it. The probe I am using is pushing the limits of my machine. In order to make sure the program is executing properly, I measure the same diameter, at the beginning and the end of the program. Reporting the difference in X and Z is easy. How do I report the difference between two diameters? I created this Variable:
ASSIGN/V1=CIR_T1A0B0_PRE.DIA-CIR_T1A0B0_POST.DIA
The nominal value is 0. It's literally the same feature measured twice. This will show me if I'm falling out of calibration. I just don't know how to report "V1". Any suggestions?
I have a situation that I believe has an easy solution...I just don't know it. The probe I am using is pushing the limits of my machine. In order to make sure the program is executing properly, I measure the same diameter, at the beginning and the end of the program. Reporting the difference in X and Z is easy. How do I report the difference between two diameters? I created this Variable:
ASSIGN/V1=CIR_T1A0B0_PRE.DIA-CIR_T1A0B0_POST.DIA
The nominal value is 0. It's literally the same feature measured twice. This will show me if I'm falling out of calibration. I just don't know how to report "V1". Any suggestions?