Dimensioning off Alignment Features.

Good Afternoon Everyone:

Lately I have been I have been adding an extra refine alignment into my measurement routines.

Ex:

Manual
manual_pocket_face (plane)
manual_male_face (plane)
manual_orgin_id (circle)

First DC
dc_pocket_face (plane)
dc_male_face(plane)
dc_orgin_id (circle)

Second DC
dcc_pocket_face (plane)
dcc_flowbore (cylinder)
dc_orgin_id (circle)

Each progression of alignments taking more points than the previous. My second dc alignment uses different features than by first dc alignment.

My question is can I dimensions a feature, such as a plane to a feature that was used in my first dc alignment.?

Female_face_plane distance to dc_male_face?