Does anybody here have direct experience with running PC-DMIS on a non-native CMM by means of an I++ DME Interface? We are running PC-DMIS 2016 on our Zeiss and we are having many measurement errors (Bore reading undersized when plug fits fine) and issues with scanning. When I set up a cylinder scan offline and try to run it on the Zeiss it tries to scan through the part.
Hex says that there is a probe mapping utility that is our responsibility to maintain, but this was all set up before I got here and I see no utility, nor does anybody here maintain one. I am the only programmer and with the money that was spent to make this happen, they want to see it working correctly. I have seen one post on here about something similar but I did not see any resolution.
Just interested to see if anybody has the experience with this.
Thank you.
Hex says that there is a probe mapping utility that is our responsibility to maintain, but this was all set up before I got here and I see no utility, nor does anybody here maintain one. I am the only programmer and with the money that was spent to make this happen, they want to see it working correctly. I have seen one post on here about something similar but I did not see any resolution.
Just interested to see if anybody has the experience with this.
Thank you.