I have tried searching for an answer to this and came up empty.
We had a batch of questionable parts made and we used the CMM to scan them. It's basic ring checking ID, OD, and a vertical scan checking for a concave or convex condition. We had 60 to check then compared reports when we were done. The question is, is there a way we could have ran all 60 parts and report to Excel but instead of creating a new report every run, have it add to the first report that was made? Basically make it to where we could look at one report with all the parts on it instead of opening and closing 60 individual reports.
Sounds like SPC reporting but we don't have Datapage and don't run enough quantity to use SPC.
Thanks.
We had a batch of questionable parts made and we used the CMM to scan them. It's basic ring checking ID, OD, and a vertical scan checking for a concave or convex condition. We had 60 to check then compared reports when we were done. The question is, is there a way we could have ran all 60 parts and report to Excel but instead of creating a new report every run, have it add to the first report that was made? Basically make it to where we could look at one report with all the parts on it instead of opening and closing 60 individual reports.
Sounds like SPC reporting but we don't have Datapage and don't run enough quantity to use SPC.
Thanks.