Good evening,
I have been given a part that has features on the top and bottom. There's A is on the bottom, B is my rotation and C is my origin. There's also D that's on the inside of the bottom of the part. My question is this, would setting this part up using two parts, one to measure the top and one to measure the bottom be a good idea? I want to make this one program and be able to recall the datum alignment from the opposite part. I hope I gave enough info. I can't show prints or draw a likeness because of itars.
I have been given a part that has features on the top and bottom. There's A is on the bottom, B is my rotation and C is my origin. There's also D that's on the inside of the bottom of the part. My question is this, would setting this part up using two parts, one to measure the top and one to measure the bottom be a good idea? I want to make this one program and be able to recall the datum alignment from the opposite part. I hope I gave enough info. I can't show prints or draw a likeness because of itars.