Hey Guys
I'm new to Pc Dmis, (I literally got my level one last week). I'm not even sure if I'm posting in the correct place! Anyhow, I need help. I'm to measure surface points on a part and I have no idea where to start. I have a CAD model and I have a proper alignment. I know how to take the surface points however I'm not sure how to dimension them for the report. There are no nominal values on the gd&t, however, there are tolerances listed for each surface area of the part. If it helps at all, the part does sit in a fixture. Any help from the gurus here would be greatly appreciated.
I'm new to Pc Dmis, (I literally got my level one last week). I'm not even sure if I'm posting in the correct place! Anyhow, I need help. I'm to measure surface points on a part and I have no idea where to start. I have a CAD model and I have a proper alignment. I know how to take the surface points however I'm not sure how to dimension them for the report. There are no nominal values on the gd&t, however, there are tolerances listed for each surface area of the part. If it helps at all, the part does sit in a fixture. Any help from the gurus here would be greatly appreciated.