Working on this program, and I have this slot that only has one rounded end. Normally, I would just make an auto-slot but I can't because of this condition. And I also, can't make an auto-notch because of the condition. Datum A is Level (not shown, up and down), and Datum B is a plane on the other end of the part controlling rotation. I can't figure out a way to dimension the true position callout on the photo.
I did make an edge point in the center of the radius (actually 2 because there are two of these slots in question). And I also constructed two lines to give me center points to pair with the edge points so I can measure the distance.
Sorry for the bad drawing, can't give out customer print and had too much coffee already.
Thanks
I did make an edge point in the center of the radius (actually 2 because there are two of these slots in question). And I also constructed two lines to give me center points to pair with the edge points so I can measure the distance.
Sorry for the bad drawing, can't give out customer print and had too much coffee already.
Thanks
