I'm using PC-DMIS 2012
I have 3 partial circles measured (that would actually be part of a whole circle if other features weren't in the way). This bore is down inside of a part and additional pieces have been welded above it.
I have extracted the hit data into an array, so I have all of the data needed to construct a full circle or cylinder (I can vary the depth of the partials if needed), but I can't find a way to pass the array data back into a constructed feaure.
I know the length of the array, but if the number of hits is changed, I would like the program to use that number from the array to add each point to the constructed feature.
2012 can't add move points inside of the circle hits like the newer versions, so as far as I can see, I have to measure 3 different arcs (or a bunch of individual points). I'm also using a star probe to get into this bore and changing the AB angle 3 times.
Customer needs to know that inside bore hasn't gone out of round after welding.
Any help would be greatly apprciated,
I have 3 partial circles measured (that would actually be part of a whole circle if other features weren't in the way). This bore is down inside of a part and additional pieces have been welded above it.
I have extracted the hit data into an array, so I have all of the data needed to construct a full circle or cylinder (I can vary the depth of the partials if needed), but I can't find a way to pass the array data back into a constructed feaure.
I know the length of the array, but if the number of hits is changed, I would like the program to use that number from the array to add each point to the constructed feature.
2012 can't add move points inside of the circle hits like the newer versions, so as far as I can see, I have to measure 3 different arcs (or a bunch of individual points). I'm also using a star probe to get into this bore and changing the AB angle 3 times.
Customer needs to know that inside bore hasn't gone out of round after welding.
Any help would be greatly apprciated,