Hi all,
I'm trying to set up the MRC20 rack with 2015.0 and having trouble with 1 probe.
I've calibrated my master probe in slot 1 and loads/unloads just fine.
I then calibrated my 5x50 probe in slot 4, again it calibrated fine.
The machine will picked up the probe in slot 6 fine and I calibrated 0,0 but when it goes to unload it, the TP20 is .100 or so below where it should be and fails to unload.
Probe build in slot 6 is comparable to the others, PH10MQ, convert 30mm to M8 thd, TP20, etc
The slot data Z dimension is the same for all other slots so I'm at a loss right now.
I'm trying to set up the MRC20 rack with 2015.0 and having trouble with 1 probe.
I've calibrated my master probe in slot 1 and loads/unloads just fine.
I then calibrated my 5x50 probe in slot 4, again it calibrated fine.
The machine will picked up the probe in slot 6 fine and I calibrated 0,0 but when it goes to unload it, the TP20 is .100 or so below where it should be and fails to unload.
Probe build in slot 6 is comparable to the others, PH10MQ, convert 30mm to M8 thd, TP20, etc
The slot data Z dimension is the same for all other slots so I'm at a loss right now.