Good Afternoon Everyone
Working on a part that has a 0.75mm profile callout with no datums. (Form only)(Profile|0.75| ) This tolerance is applied to a curved surface. I have measured this surface using vector points and created a feature set from the points. Dimensioned the feature set using profile and selected form only and applied 0.75 for tolerance. Could someone please explain why the profile show out of tolerance (red) when all the points fall within a 0.411mm wide band??
Thanks
Scott
Working on a part that has a 0.75mm profile callout with no datums. (Form only)(Profile|0.75| ) This tolerance is applied to a curved surface. I have measured this surface using vector points and created a feature set from the points. Dimensioned the feature set using profile and selected form only and applied 0.75 for tolerance. Could someone please explain why the profile show out of tolerance (red) when all the points fall within a 0.411mm wide band??
Thanks
Scott