So I got to thinking about this. I have a part with several small, shallow cones hat have angularity callouts. Say the axis of the cone is along Z, the cone has a half angle of 10°. I program a set of individual hits, then create a set out of them.
The question is this - if I then did a best fit, translate in Z only, then report the profile, didn't I just meet the angularity requirement (assuming my point THEOs are correct (and they are)).?
The question is this - if I then did a best fit, translate in Z only, then report the profile, didn't I just meet the angularity requirement (assuming my point THEOs are correct (and they are)).?