Hi, I recently installed PC-DMIS on a new pc. Some problems occured (mostly solved now), but there is one problem that is still remaining:
When a scan is performed (and this is for all measurement programs which didn't had this problem before the new installation) the output of the scan gives me measured values which have a big offset from the nominals, butttt when I opend "Show hits" then I see correct values for the measured values. When I make a circle of this scan and the theoratical needs to be, for instance (20,40,10) it gives me a measured value of (135.66 ; -88.34 ; 55.66)???
When performing the scan, the probe is in a different place in "Graphic display window" and after the scan it places the scan in a total different place?
Did anyone had this problem? It only occurs with scans, with all the other features it is okay.
When a scan is performed (and this is for all measurement programs which didn't had this problem before the new installation) the output of the scan gives me measured values which have a big offset from the nominals, butttt when I opend "Show hits" then I see correct values for the measured values. When I make a circle of this scan and the theoratical needs to be, for instance (20,40,10) it gives me a measured value of (135.66 ; -88.34 ; 55.66)???
When performing the scan, the probe is in a different place in "Graphic display window" and after the scan it places the scan in a total different place?
Did anyone had this problem? It only occurs with scans, with all the other features it is okay.