Hello I was wondering about best fitting bolt hole circle when one is NOT designated as datum -C-.When all holes in a pattern are picked and then 2d rotate no translate is used.
Does that influence xact measure calculation or is it only for legacy dimensioning?
My second question very basic but I wanted to clarify that.
in the above scenario
my aligment would be
1 Level Z+ top surface,origin Z on surface
2 Origin X,Y on Dia B
3 rotate from B to C
Now do I copy hole -C- at this point(from before aligment) and paste it with pattern or do I create another hole -C- after aligment is finished and then pate it with pattern.
Does that matter?
Does that influence xact measure calculation or is it only for legacy dimensioning?
My second question very basic but I wanted to clarify that.
in the above scenario
my aligment would be
1 Level Z+ top surface,origin Z on surface
2 Origin X,Y on Dia B
3 rotate from B to C
Now do I copy hole -C- at this point(from before aligment) and paste it with pattern or do I create another hole -C- after aligment is finished and then pate it with pattern.
Does that matter?