I just got done building a custom shank probe thanks to the help of Mikeg, I verified that my build was good by checking a 321 block, everything looked good. Now that I'm adding this custom probe to my 6 port rack I am running into a calibration problem (my acutal program where the custom probe will be used), first I calibrate probe 2 (port 2) works fine, than when I try to calibrate my new port 6 probe it asks me the question if my A0BO has moved my answer is NO meaning the port 6 should go straight to the calibration sphere in relation to port 2 but it does not do that it misses the sphere. Any ideas why this is happening?
↧